Konica Minolta 750 manual Copy Paper/Original Chapter

Copy Paper/Original 7

4Type in the length (X) and width (Y) of the paper.

–Touch [X], touch [↔] to switch between the integer and the fraction, and then touch [–] and [+] to type in the length of side X. (5-1/2 in. to 18 in.)

–Touch [Y], touch [↔] to switch between the integer and the fraction, and then touch [–] and [+] to type in the length of side Y. (3-15/16 in. to 12-5/16 in.)

–If a decimal value is displayed in the screen, use the keypad to type in the length. For details on switching between decimal and fraction values, refer to “System Setting” on page 12-14.

–If a decimal value is displayed in the screen and the specified value is outside the allowable range, the message “Input Error” appears. Type a value within the allowable range. If the value was incorrectly entered, press the [C] (clear) key to erase the value, and then spec- ify the correct value.

?Can paper sizes be stored?

%Two specified non-standard paper sizes can be stored.

%For details on storing paper sizes, refer to “To store a non-standard paper size (Custom Size settings Store)” on page 7-14.

%To recall a stored paper size, touch [memory1] or [memory2].

%The names of the stored paper sizes “memory1” and “memory2” can be changed. For details on changing the names, refer to “To store a non-standard paper size (Custom Size settings Store)” on page 7-14.

5Touch [OK] three times.

The Basic screen appears again.

Copy Paper/Original Chapter 7

bizhub 750/600 7-13