Adjusting the Pitch of the Two Staples

Utility Chapter 12

12	Utility

–If the folding position is too far on the left side of the paper, touch [–] (between –0.1 mm and –12.8 mm).

12 Repeat steps 6 through 11 until the desired print results are achieved.

13 Touch [OK].

–To cancel changes to the settings, touch [Cancel].

Note

Enter the value by mm using the keypad. Refer to the conversion rate be- low. 1 in. = 25.4 mm

The distance between the two staples can be adjusted.

0Use the “2 Position” Staple function to print a single sample copy, and then perform the adjustment while checking the sample that was created.

0[6 2 Position Staple] appears only if finisher FS-602 is installed.

1Display the Administrator Setting screen.

2Touch [1 System Setting].

The System Setting screen appears.

3Touch [7 Expert Adjustment].

The Expert Adjustment screen appears.

4Touch [5 Finisher Adjustment].

The Finisher Adjustment screen appears.

12-68