Konica Minolta manual Adjusting the Z-Fold Positions, Bizhub 750/600 12-63

Utility 12

13 Repeat steps 7 through 11 until the desired print results are achieved.

14 Touch [OK].

–To cancel changes to the settings, touch [Cancel].

Note

Enter the value by mm using the keypad. Refer to the conversion rate be- low. 1 in. = 25.4 mm

When PK-505 and ZU-602 are installed, adjustments can be made using both the “Punch Adjustment” and “Z-Fold Position Adjustment” param- eters. Contact your technical representative.

Adjusting the Z-Fold Positions

The first and second folding positions for Z-Fold can be adjusted.

0Use the “Z-Fold” function to print a single sample copy, and then perform the adjustment while checking the sample that was created.

When making adjustments to settings for both the “1st Z-Folded Posi- tion” and “2nd Z-Folded Position”, be sure to first adjust the setting for the “1st Z-Folded Position”.

0The Z-fold position can be adjusted only when optional Z-folding unit ZU- 602 is installed.

1Display the Administrator Setting screen.

2Touch [1 System Setting].

The System Setting screen appears.

3Touch [7 Expert Adjustment].

The Expert Adjustment screen appears.

4Touch [5 Finisher Adjustment].

The Finisher Adjustment screen appears.

5Touch [4 Z-Fold Position Adjustment].

The Z-Fold Position Adjustment screen appears.

Utility Chapter 12

bizhub 750/600 12-63