Konica Minolta 750 manual Check the distances b, From the print position, Test pattern to

Utility Chapter 12

12	Utility
	9 Check the distances (b)
	from the print position of
	the test pattern to the
	edge of the paper.
	b

10 If the desire print results are not achieved, change the adjustment value.

–To increase distance (b), touch [+].

–To reduce distance (b), touch [–].

–Each time [+] or [–] is touched, the value is increased or decreased by one increment.

11 Repeat steps 6 through 10 until the desired print results are achieved. 12 Touch [OK].

–To cancel changes to the settings, touch [Cancel]. The print position is adjusted.

Note

Enter the value by mm using the keypad. Refer to the conversion rate be- low. 1 in. = 25.4 mm

12-44 bizhub 750/600