Konica Minolta 750 manual Adjusting the Tri-Fold Positions

Utility Chapter 12

12 Utility

13 Repeat steps 7 through 12 until the desired print results are achieved.

14 Touch [OK].

–To cancel changes to the settings, touch [Cancel].

Note

Enter the value by mm using the keypad. Refer to the conversion rate be- low. 1 in. = 25.4 mm

When PK-505 and ZU-602 are installed, adjustments can be made using both the “Punch Adjustment” and “Z-Fold Position Adjustment” param- eters. Contact your technical representative.

Adjusting the Tri-Fold Positions

The folding positions when using the “Tri-Fold” setting can be adjusted.

0Use the “Tri-Fold” function to print a single sample copy, and then per- form the adjustment while checking the sample that was created.

1Display the Administrator Setting screen.

2Touch [1 System Setting].

The System Setting screen appears.

3Touch [7 Expert Adjustment].

The Expert Adjustment screen appears.

4Touch [5 Finisher Adjustment].

The Finisher Adjustment screen appears.

5Touch [5 Tri-Fold Position].

The Tri-Fold Position screen appears.

12-66 bizhub 750/600