Konica Minolta 750 manual Finisher

5

Troubleshooting Chapter 5

		Troubleshooting
Finisher
Symptom	Possible Cause	Remedy
The finisher cannot be	Is there a paper misfeed in	If there is a paper misfeed, clear it.
used.	the finisher?
	Is the finisher door fully	Securely close the finisher door.
	closed?
The pages cannot be	Have the staples run out?	Replace the staple cartridge. (See
stapled.		p. 9-7.)
The staple is incorrectly	Are the staples positioned as	Select the desired position for the
positioned by 90 de-	specified?	staples. (See p. 3-59.)
grees.
The pages that were fed	Is the paper curled?	Remove the paper from the paper
out were not uniformly		tray, turn it over, and then load it
loaded and the punched		again.
holes or staples are in-
	Is there a gap between the	Slide the lateral guides in the paper
correctly positioned.
	lateral guides in the paper	tray against the side of the paper so
	tray and the side of the pa-	that there is no gap.
	per?
Even though a Punch	Did the message “Remove	Empty the punch dust box
setting was selected,	Punch Scraps.” appear?
holes are not punched.
(when PK-505/ZU-602 is
installed on FS-504/FS-
602)

If any message other than those listed above appears, perform the operation described in the message.

If the problem is not corrected after the described operation is performed, contact your technical representative.

5-14 bizhub 750/600