Konica Minolta manual Bizhub 750/600 12-51

Utility 12

–If the punch positions are too far below the center of the paper, touch [–] (between –0.1 mm and –5.0 mm).

13 Repeat steps 7 through 12 until the desired print results are achieved.

14 Touch [OK].

–To cancel changes to the settings, touch [Cancel].

Note

Enter the value by mm using the keypad. Refer to the conversion rate be- low. 1 in. = 25.4 mm

When PK-505 and ZU-602 are installed, adjustments can be made using both the “Punch Adjustment” and “Z-Fold Position Adjustment” param- eters. Contact your technical representative.

Utility Chapter 12

bizhub 750/600 12-51