4. Slide the paper guide ➊ to the mark for the size of the media you are loading.
5. Hold the sheet with the print side up and align the left edge of the sheet with the stopper ➋ on the left side of the front cover.
Stopper
2
3
Mark for the size | 1 |
Paper guide
6. Insert the paper straight into the printer ➌ (about 5 cm) until it stops. Push the sheet in slightly and hold it in place for about two seconds. The sheet will feed partially into the printer.
•If the sheet is too narrow (less than 100 mm), or if the sheet is inserted diagonally, the buzzer will beep once, the CHARGE/ERROR lamp will flash, and the printer will eject the paper from the feed slot. After the sheet is inserted again correctly, the printer will reverse feed it slightly and the buzzer will not beep. If POWER lamp is flashing, data remains to be printed. Press the RESUME button to finish the print job.
•If the POWER lamp lights and remains on, remove the sheet and then load it again.
7. Start the print job with your software application.
50 Chapter 3 Printing