Chapter 3 Installing the Cisco ADE 2130 and 2140 Series Appliance
Removing or Replacing the Cisco ADE 2130 and 2140 Series Appliance
1. When pressed, clears the processor allowing the processor to continue to execute the software normally.
The following LEDs provide power, activity, and status information:
ADE 2130 and 2140 Appliance Front-Panel LEDs
•Appliance power, green:
–On when power is on.
–Off when power is off or an error condition has been detected in the operating voltages.
•Hard disk activity, green:
–On when appliance software has booted up, and the appliance is operational.
–Off when appliance has not yet booted, or an error condition has been detected in the boot process.
•NIC 1 or NIC 2, green:
–On when packets are transferring
–Off when no packets are transferring
For more detailed information about the LEDs, see Appendix A, “Troubleshooting.”
Removing or Replacing the Cisco ADE 2130 and 2140 Series Appliance
Warning Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord. Statement 1
Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040
To remove a Cisco ADE 2130 and 2140 Series appliance from your network, power it down, disconnect the power cords and network cables, and physically remove the appliance from the rack.
The appliance is in constant communication on your network; thus, when the network notices that the appliance is no longer responding to it, the network stops sending requests to the appliance. This change is transparent to users. If other appliances are attached to the network, the network continues sending requests to the other appliances.
To replace an appliance, remove it from the network. Then, install a new appliance and configure it using the same configuration parameters that you used for the removed appliance.
Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide
| ||
|
