Cisco Systems 2140, 2130 manual Removing a PCI Adapter Card, Removing a Full-Height Adapter Card

Chapter 4 Installing the Cisco ADE 2130 and 2140 Series Appliance Hardware Options

Removing and Installing the PCI Adapter Card

Step 7 Note the location of the pins on each side of the rear-panel opening where the riser adapter card assembly bracket attaches. (See location 2 in Figure 4-7 on page 4-14).

Step 8 To remove a PCI adapter card, go to the “Removing a PCI Adapter Card” section on this page. Step 9 If you removed the PCI riser assembly for another procedure, continue with that procedure.

Step 10 If you have other hardware options to install, do so now; otherwise, go to the “Completing the Installation” section on page 4-20.

Removing a PCI Adapter Card

To remove a PCI adapter card:

Step 1 Review the information in the “Safety Warnings” section on page x and the “Safety Guidelines” section on page 2-2.

Step 2 Power down the appliance and all external devices. Disconnect the AC power cord or DC power source and all external cables.

Step 3 Attach the antistatic wrist strap to your wrist and connect its cord to the ESD socket on the top, left-hand side on the front of the appliance.

Step 4 Remove the appliance cover. For instructions, see the “Removing the Cover” section on page 4-3. Step 5 Disconnect any cables attached to any adapter cards.

Step 6 Remove the PCI riser assembly. For instructions, see the “Removing the PCI Riser Assembly” section on page 4-14. Then, turn the riser adapter card assembly upside down to remove the adapter card.

Step 7 Remove the rear retention screw that fastens the adapter card to the rear bracket. (See location 1 or 4 in Figure 4-8.)

Figure 4-8 Removing a Full-Height Adapter Card

D4

E5

A1

C3

B2

231204

Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide

78-18579-02 4-15