Cisco Systems 2130 Attaching the Inner Slide Rails to the Appliance, Item No Description Quantity

Chapter 3 Installing the Cisco ADE 2130 and 2140 Series Appliance

Mounting the Cisco ADE 2130 and 2140 Series Appliance in a 4-Post Rack

Figure 3-5 4-Post Rack-Mount Hardware Kit

3

1 2 4

	203370
Table 3-2	4-Post Rack-Mount Hardware Kit
Item No.	Description	Quantity
1	Rack screw, 10-32 x 1/2-inch (1.27 cm)	12
2	Screw, 8-32 x 3/8-inch (.95 cm)	8
3	Nut bar1	4
4	Cage nut, 10-32 x 3/8-inch (.95 cm)2	12
—	Screw, 6-32 x 1/4-inch (.63 cm)3	8

1.Nut bar used in unthreaded round-hole racks or used over the cage nuts for square-hole racks.

2.Cage nuts are used only when mounting in square-hole racks.

3.Not shown in Figure 3-5. Depending on rack type, can be used in place of 8-32 x 3/8-inch screws.

Attaching the Inner Slide Rails to the Appliance

To install the Cisco ADE 2130 and 2140 Series appliance into the slide rails:

Step 1 Align the inner slide rail holes with the horizontal holes on the side of the appliance beginning with the second hole. The release spring on the inner slide rail must point toward the rear of the appliance and face away from the appliance chassis. (See Figure 3-6.)

Figure 3-6 Aligning the Inner Slide Rail with the Mounting Studs

231555

Step 2 Attach the inner slide rail to the appliance with the 8-32 x 3/8-inch screws.

Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide

3-8 78-18579-02