Chapter 3 Installing the Cisco ADE 2130 and 2140 Series Appliance
Powering Up the Cisco ADE 2130 and 2140 Series Appliance
Power-Up Procedure (DC Power Supply)
To power up a Cisco ADE 2130 and 2140 Series appliance with a DC power supply and verify its initialization and
If a redundant power supply is used, separate DC power sources are needed for each power supply. This allows you to turn off power for one power supply without affecting the power source for the other.
Step 1 Review the information in the “Safety Guidelines” section on page 2-2.
Step 2 Plug the Molex terminal block connector into the power connector located on the rear
Step 3 Connect the DC power input wires to the DC power source at your installation site.
Step 4 Press the power button on the front of the appliance. (See location 9 in Figure
The appliance should begin its powerup procedure.
Step 5 After the operating system boots up, observe the
properly. (See Figure
Once the operating system boots, you are ready to initialize the basic software configuration. (See the software installation guide or user guide that shipped with your appliance, for proper configuration procedures.)
Checking the LEDs
When the Cisco ADE 2130 and 2140 Series appliance is up and running, observe the
Figure 3-13 Cisco ADE 2130 and 2140 Series Appliance Front Control Panel
A1 B2 C3 D4 E5
9I H8 G7 F6
231190
| 1 | Appliance power LED | 6 | ID control switch (push button) | ||||
|
|
|
|
| ||||
2 | Appliance status LED | 7 | NMI (nonmaskable interrupt) recessed | |||||
|
|
|
|
| button1 | |||
3 | Hard disk drive activity LED | 8 | Reset push button | |||||
|
|
|
|
| ||||
4 | NIC activity (all NICs) | 9 | Appliance power push button | |||||
|
|
|
|
|
|
|
| |
5 | Appliance system ID LED |
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
|
| Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide |
|
| |||
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| |||
