Cisco Systems C819GUK9, C819HG4GVK9 3G-ACC-OUT-LA-See Cisco 3G Lightning Arrestor 3G-ACC-OUT-LA

Chapter 5 Basic Router Configuration

Information Needed for Configuration

•If you are setting up IP routing:

–Generate the addressing scheme for your IP network.

•If you are setting up the serial interface:

–Mode of operation (sync, async, bisync)

–Clock rate depending on the mode

–IP address depending on the mode

•If you are setting up 3G:

–You must have service availability on the Cisco 819 ISR from a carrier, and you must have network coverage where your router will be physically placed. For a complete list of supported carriers, see the data sheet at Cisco 3G Wireless Connectivity Solutions.

–You must subscribe to a service plan with a wireless service provider and obtain a SIM card.

–You must install the SIM card before configuring the 3G Cisco 819 ISR. For instructions on how to install the SIM card, see Cisco 800 Series RoutersConfiguring Cisco EHWIC and 880G for 3.7G (HSPA+)/3.5G (HSPA).

•You must install the required antennas before you configure the 3G for Cisco 819 ISR. See the following URLs for instructions on how to install the antennas:

–3G-ANTM1919D—SeeCisco Multiband Swivel-Mount Dipole Antenna (3G-ANTM1919D).

–3G-ANTM1916-CM—SeeCisco Multiband Omnidirectional Ceiling Mount Antenna (3G-ANTM1916-CM).

–3G-AE015-R (Antenna Extension)—SeeCisco Single-Port Antenna Stand for Multiband TNC Male-Terminated Portable Antenna (Cisco 3G-AE015-R).

–3G-AE010-R (Antenna Extension)—SeeCisco Single-Port Antenna Stand for Multiband TNC Male-Terminated Portable Antenna (Cisco 3G-AE015-R).This document applies to both

3G-AE015-R and 3G-AE010-R. The only difference between these two products is the length of the cable.

–3G-ANTM-OUT-OM—SeeCisco 3G Omnidirectional Outdoor Antenna (3G-ANTM-OUT-OM).

–3G-ANTM-OUT-LP—SeeCisco Multiband Omnidirectional Panel-Mount Antenna (3G-ANTM-OUT-LP).

–3G-ACC-OUT-LA—SeeCisco 3G Lightning Arrestor (3G-ACC-OUT-LA).

–4G-ANTM-OM-CM—SeeCisco 4G Indoor Ceiling-Mount Omnidirectional Antenna (4G-ANTM-OM-CM).

•You must check your LEDs for signal reception as described in Table 2-1.

•You should be familiar with the Cisco IOS software. See the Cisco IOS documentation beginning with Release 12.4(15)T or later for Cisco 3G support.

•To configure your 3G data profile, you will need the username, password, and access point name (APN) from your service provider:

After you have collected the appropriate information, you can perform a full configuration on your router, beginning with the tasks in the “Configuring Command-Line Access” section on page 5-5.

To obtain or change software licenses:

•See Software Activation on Cisco Integrated Services Routers and Cisco Integrated Service Routers G2.

Cisco 819 Series Integrated Services Router Software Configuration Guide

5-4 OL-23590-02