Cisco Systems C819HG4GVK9, C819GUK9 manual Configure the Fast Ethernet WAN Interfaces, 11-3

Chapter 11 Configuring PPP over Ethernet with NAT

Configuration Tasks

DETAILED STEPS

	Command or Action	Purpose
Step 1
	vpdn enable	Enables VPDN on the router.
	Example:
	Router(config)# vpdn enable
	Router(config)#
Step 2
	vpdn-group name	Creates and associates a VPDN group with a
	Example:	customer or VPDN profile.
	Router(config)# vpdn-group 1
	Router(config-vpdn)#
Step 3
	request-dialin	Creates a request-dialin VPDN subgroup,
	Example:	indicating the dialing direction, and initiates the
		tunnel.
	Router(config-vpdn)# request-dialin
	Router(config-vpdn-req-in)#
Step 4
	protocol {l2tp pppoe}	Specifies the type of sessions the VPDN subgroup
	Example:	can establish.
	Router(config-vpdn-req-in)# protocol pppoe
	Router(config-vpdn-req-in)#
Step 5
	exit	Exits request-dialin VPDN group configuration.
	Example:
	Router(config-vpdn-req-in)# exit
	Router(config-vpdn)#
Step 6
	exit	Exits VPDN configuration, returning to global
	Example:	configuration mode.
	Router(config-vpdn)# exit
	Router(config)#

Configure the Fast Ethernet WAN Interfaces

In this scenario, the PPPoE client (your Cisco router) communicates over a 10/100 Mbps-Ethernet interface on both the inside and the outside.

Perform these steps to configure the Fast Ethernet WAN interfaces, starting in global configuration mode:

	Cisco 819 Series Integrated Services Routers Software Configuration Guide
OL-23590-02		11-3