Cisco Systems C819GUK9 manual ip name-server server-address 2. ip dhcp pool name 3. exit, 6-10

Chapter 6 Configuring Backup Data Lines and Remote Management

Configuring Dial Backup and Remote Management Through the Console Port

To configure dial backup and remote management for these routers, perform these steps, beginning in global configuration mode:

SUMMARY STEPS

1.ip name-server server-address

2.ip dhcp pool name

3.exit

4.chat-scriptscript-name expect-send

5.interface type number

6.exit

7.interface type number

8.dialer watch-group group-number

9.exit

10.ip nat inside source {list access-list-number}{interface type number pool name} [overload]

11.ip route prefix mask {ip-address interface-type interface-number [ip-address]}

12.access-listaccess-list-number {deny permit} source [source-wildcard]

13.dialerwatch-list group-number{ip ip-addressaddress-mask delay route-check initial seconds}

14.line [aux console tty vty] line-number[ending-line-number]

15.modem enable

16.exit

17.line [aux console tty vty] line-number[ending-line-number]

18.flowcontrol {none software [lock] [in out] hardware [in out]}

	Cisco 819 Series Integrated Services Routers Software Configuration Guide
6-10	OL-23590-02