Chapter 5 Basic Router Configuration
Configuring Static Routes
Output queue 0/0, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Another way to verify the loopback interface is to ping it:
Router# ping 200.200.100.1 Type escape sequence to abort.
Sending 5,
!!!!!
Success rate is 100 percent (5/5),
Configuring Static Routes
Static routes provide fixed routing paths through the network. They are manually configured on the router. If the network topology changes, the static route must be updated with a new route. Static routes are private routes unless they are redistributed by a routing protocol.
Follow these steps to configure static routes, beginning in global configuration mode.
SUMMARY STEPS
1.ip route prefix mask
2.end
DETAILED STEPS
| Command |
| Purpose |
Step 1 |
|
| |
ip route prefix mask | Specifies the static route for the IP packets. | ||
| For details about this command and about | ||
| |||
|
|
| additional parameters that can be set, see Cisco |
| Example: |
| IOS IP Routing: |
| Router(config)# ip route 192.168.1.0 | Reference. | |
|
| ||
| 255.255.0.0 | 10.10.10.2 |
|
| Router(config)# |
| |
Step 2 |
|
|
|
end |
| Exits router configuration mode and enters | |
| Example: |
| privileged EXEC mode. |
|
|
| |
| Router(config)# end |
| |
| Router# |
|
|
|
|
|
|
For general information on static routing, see the “Floating Static Routes” section on page
|
| Cisco 819 Series Integrated Services Router Software Configuration Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
| ||
