Chapter 9 Routine Procedures

Enabling or Disabling Your Client Adapter’s Radio

Note If your client adapter’s radio is disabled before your computer enters standby or hibernate mode or before you reboot the computer, the radio remains disabled when the computer resumes. You must enable the radio to resume operation.

You can use ADU or ASTU to enable or disable the client adapter’s radio. Follow the instructions below to use ADU or refer to the “Enable/Disable Radio” section on page 8-7to use ASTU.

If your client adapter’s radio is enabled, open ADU and choose Disable Radio from the Action drop-down menu (see Figure 9-4) to disable the radio.

If your client adapter’s radio is disabled, open ADU and choose Enable Radio from the Action drop-down menu (see Figure 9-4) to enable the radio.

Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide

9-10

OL-4211-03

 

 

Page 176
Image 176
Cisco Systems CB21AG manual OL-4211-03