F-11
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide for Windows
OL-4211-03
AppendixF Performing a Site Survey Using the AP Scan List Tab
Pausing the AP Scan List
The AP scan list is updated continually. To pause t he cur rent list, click P ause List Update above the AP
scan list.
Note Clicking this button again resumes the list update.
AP Name The access point’s name. It is shown only if the access point was configured
with a name, Aironet Extensions are enabled (on access points running Cisco
IOS Release 12.2(4)JA or later), and the access point transmits this
information.
Note This field shows up to 15 characters although the name of the access
point may be longer.
CCX The version of Cisco Compatible Extensions (CCX) supported by the access
point. It is shown only if the access point transmits this information.
Valu e: 1, 2, 3, or 4
Other Information A list of miscellaneous values that may appear depending on the access
point’s current status and the information that it transmits.
Valu es: Ad-Hoc, Power, Qos, RM-Normal, RM-Source, and Ssidl
Value Description
Ad-Hoc Indicates that the device is not an access point but another
client adapter operating in ad hoc mode.
Power Indicates whether the access point can limit the transmitting
power of the client adapter. If so, the power limit is also shown
in milliwatts (mW).
Qos Indicates whether the access point is using quality of service
(QoS). QoS on wireless LANs (WLAN) provides
prioritization of traffic from the access point over the WLAN
based on traffic classification.
RM-Normal
RM-APScan
RM-CliWlk
Indicates whether the access point is using radio management.
If so, a value of 1 indicates normal status, 2 indicates AP radio
scan, and 3 indicates client walkabout. Any other value
appears as RM-State:xxx, where xxx represents a numerical
value.
RM-Source Indicates whether the access point is using radio management
extensions and displays the MAC address of the radio
management source (for example, RM-Source:
00-07-85-B4-04-9F).
Ssidl Indicates the number of advertised alternate SSIDs (for
example, Ssidl:2).
TableF-2 Site Survey Utility - AP Scan List (continued)
AP Scan List Parameter Description