Cisco Systems CB21AG manual Wmm

Chapter 7 Viewing Status and Statistics

Viewing the Current Status of Your Client Adapter

Table 7-4	Advanced Client Adapter Status (continued)
Status		Description
QoS		The type of quality of service that is currently being used by your client
		adapter. QoS on wireless LANs (WLAN) provides prioritization of
		traffic from the access point over the WLAN based on traffic
		classification.
		Value:	None or WMM
		QoS		Description
		None		WMM standard QoS is not enabled.
		WMM		Wi-Fi Multimedia, a component of the
				IEEE 802.11e WLAN standard for QoS, is
				enabled. For this value to appear, QoS and
				WMM must be enabled on the access point
				to which the client adapter is associated.
		Note WMM is supported automatically on the client adapter in the
			software included in Install Wizard 2.0 or later. However, you
			must enable the Windows QoS Packet Scheduler to ensure
			WMM support. Follow the instructions in the “Enabling Wi-Fi
			Multimedia” section on page 5-51to enable the QoS Packet
			Scheduler.
Associated AP Name		The name of the access point to which your client adapter is associated.
		It is shown only if the client adapter is in infrastructure mode, the
		access point was configured with a name, and Aironet Extensions are
		enabled (on access points running Cisco IOS Release 12.2(4)JA or
		later).
		Note This field shows up to 15 characters although the name of the
			access point may be longer.
Associated AP IP Address		The IP address of the access point to which your client adapter is
		associated. It is shown only if the client adapter is in infrastructure
		mode, the access point was configured with an IP address, and Aironet
		Extensions are enabled (on access points running Cisco IOS Release
		12.2(4)JA or later).
		Note If Aironet Extensions are disabled, the IP address of the
			associated access point is shown as 0.0.0.0.
Associated AP MAC Address		The MAC address of the access point to which your client adapter is
		associated. It is shown only if the client adapter is in infrastructure
		mode.
		Note This field displays the MAC address of the access point’s
			Ethernet port (for access points that do not run Cisco IOS
			software) or the MAC address of the access point’s radio (for
			access points that run Cisco IOS software). The MAC address
			of the Ethernet port on access points that run Cisco IOS
			software is printed on a label on the back of the device.

Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide

OL-4211-03 7-9