Advanced Setup – Part 1

Audio Input Setup

• Make the audio-related settings.

Setting the Digital In Assignment

This assigns the digital input terminals for the different input sources.

1 Press the CURSOR D or H button to select “Audio Input Setup” at the “System Setup Menu”, then press the ENTER button.

• The “Audio Input Setup” menu appears.

The OPTICAL 3, 4 and 5 terminals on the AVR-5805CI’s rear panel are equipped with an optical digital output terminal for recording digital audio signals to a CD recorder, MD recorder, or other digital audio recording deck. Use this for digital recording between a digital audio source (stereo – 2 channel) and a digital audio recorder.

“PHONO” and “TUNER” cannot be selected on the “Digital In Assign” screen.

Do not connect the output of the component connected to the OPTICAL 3 (to 5) OUT terminal on the AVR-5805CI’s rear panel to any terminal other than the OPTICAL 3 (to 5) IN terminal.

2 Press the CURSOR D or H button to select “Digital In Assign”, then press the ENTER button.

• The “Digital In Assign” screen appears.

3 Press the CURSOR D or H button to select the input source, then press the CURSOR F or G button to select the digital input terminal.

Select from among COAX 1 to 6, OPT 1 to 5.

If the same digital input terminal is selected, the

setting for the input source that was previously

assigned switches to “OFF”.

The HDMI input terminal is displayed when it is

assigned to the input source at “HDMI/DVI In Assign”

(

page 111, 112).

If an input source is assigned to a device connected with an IEEE1394 cable at “IEEE1394 Assign”, the digital input terminal’s assignment setting switches to “OFF”.

When “Default Yes” is selected, then press the CURSOR F button to reset to the default values.

4

Press the ENTER button to enter the setting.

 

 

• The “Audio Input Setup” menu reappears.

2Setting the DENON LINK

When a DENON DVD player and the DENON LINK have been connected, be sure to make a setting to “DENON LINK” with the System Setup Digital In Assignment.

When the input mode is AUTO and the signals are not be able to transferred by DENON LINK, the unit automatically changes over the input to the selected signals (ANALOG, EXT. IN or IEEE1394).

Refer to “DENON LINK connections” ( page 35).

1 Press the CURSOR D or H button to select the input source, then press the CURSOR F or G button to select “DLINK”.

2 Press the CURSOR D or H button to select “DLINK” setting, then press the CURSOR F or

Gbutton to select the input signal (ANALOG, EXT. IN or IEEE1394).

If the signal cannot be played with DENON LINK connection, the signal automatically switches to the input from the set terminal.

104