Advanced Operation

 

IR segment

Point the remote control units straight at each

AMP

5 other and press and hold in the button on the

MODE SELECTOR

other remote control unit to be learnt on the
AVR-5805CI’s remote control unit.
SYSTEM CALL

• The display turns on again and the IR segment blinks

 

twice to indicate that the code is successfully

 

captured.

 

Other remote

 

control unit

CHANNEL

NUMBER

RC SETUP

Setting the learning function

•If your AV device is a brand other than DENON or if operation is not possible using the preset memory function, the signals of a remote control unit of that device can be stored in the AVR-5805CI’s remote control unit.

•For some remote control units, it may not be possible to learn the signals or the device may not operate properly after the signals are learnt. In this case, use the remote control unit of that device.

1 Press and hold the RC SETUP button for at least 3 seconds.

• The IR segment blinks twice.

2 Press the 9, 7, 5 button (9 → 7 → 5) in that order.

•The IR segment blinks twice and the learning mode is set.

3 Press the MODE SELECTOR button for the device to be operated.

Learning is not possible for the AMP, ZONE2, ZONE3, ZONE4 and SYSTEM CALL modes.

4 Press the button to be set.

• The display will go off and the unit will enter the learning standby mode.

If a button that cannot be learnt is pressed, the IR segment lights and the setting is canceled.

Cannot be set at the HOME button.

The AVR-5805CI’s remote control unit (RC-1036)

Other buttons can be learnt by repeating steps 4 and 5. The mode can be switched by pressing a MODE SELECTOR button.

If the IR segment displays one long blink, a leaning error has occurred. Try repeating this step again until a successful capture occurs.

6 Press and hold the RC SETUP button for at least 3 seconds.

•The IR segment blinks twice and the setting is completed.

•To cancel the learning setup mode, press and hold the RC SETUP button for at least 3 seconds.

NOTE:

• Do not try to learn anything to the RC SETUP button.

Using the system call function

•A series of operations can be registered at a single button.

•This function makes it possible to for example turn the amplifier’s power on, select the input source, turn the monitor power’s on, turn the source device’s power on and start playback, all by pressing a single button once.

•Up to 32 signals each can be stored at the SYSTEM CALL button (1, 2 or 3).

84