Advanced OperationIR segment

MODE SELECTOR

NUMBER

RC SETUP

There may be several preset codes for some brands. If the remote control unit does not work properly with one code, try inputting another code.

Buttons that have been learned have priority over the signals set with the preset memory function. If a learned button

setting is not needed, please erase it ( page 86).

Operating a component stored in the preset memory

1 Press the MODE SELECTOR button for the device to be operated.

• The indicator of the device to be operated blinks.

2 Operate the component.

For details, refer to the component’s operating instructions.

Setting the preset memory function

The various devices can be operated by setting the preset memory on the attached remote control unit.

For some models the remote control unit or the device may not operate properly. In this case, use the learning function

( page 84) to store your device’s remote control signals in the attached remote control unit.

1 Press the MODE SELECTOR button for the device to be set in the preset memory.

Presetting is not possible for the AMP, ZONE2, ZONE3, ZONE4, TUNER and SYSTEM CALL modes.

2 Press and hold the RC SETUP button for at least 3 seconds.

The IR segment blinks twice and the input mode is set.

3 Input the (5-digit) number for the brand of the device to be set in the preset memory, as shown

on the list of preset codes (End of this
manual).

 

The IR segment blinks twice when the memory is set.

When a preset code is transmitted, the mode indicator for the device to which that code belongs blinks.

The input mode is canceled if no operation is performed for 10 seconds.

1, 8 9,

6 7, 3, 2

A ~ G,ª, EL Display
SOURCE (SRC) ONSOURCE (SRC) OFFBAND, MODE, MEMOSETUPENTER D H F G DISPSRCHMENUButtonsCH +, – 0 ~ 9, +10SFTTV/VCR

82