Fader function

This function makes it possible to lower the volume of the front channels (FL, C and FR) or the rear channels (SL, SR, SBL and SBR) together. Use it for example to adjust the balance of the sound from each position when multi-channel music sources are played.

1 Press the CH SEL/ENTER button.

• The “Channel Vol.” screen appears.

2 Press the CURSOR D , H or CH SEL/ENTER button then select “Fader”.

The channel switches in the order shown below each time the CH SEL/ENTER button is pressed.

FL C FR SW SRASRB

FADERSLASLBSBLSBR

3 Press the CURSOR F button to reduce the volume of the front channels, the CURSOR G button to reduce the volume of the rear channels.

Example: When “FRONT” is selected

The fader function does not affect the subwoofer channel.

The channel whose channel level is adjusted lowest can be faded to –12.0 dB using the fader function.

If the channel levels are adjusted separately after adjusting the fader, the fader adjustment values are cleared, so adjust the fader again.

Basic Operation

Listening to the Radio

• Check that the remote control unit is set to AMP or TUNER.

Auto tuning1 Set the input source to “TUNER”.

(Main unit)

(Remote control unit

 

in the AMP mode)

 

 

2 Press the TU (TUNER) button to select the TUNER mode.

(Remote control unit)

3 Watching the display, press the BAND button to select the desired band (AM, FM or XM).

When listening to the XM satellite Radio ( page 71).

4 Pressmode.the MODE button to set the auto tuning

• The “AUTO” indicator lights.

5 Press the TUNING button.

• Automatic searching begins, then stops when a station is tuned in.

• If tuning does not stop at the desired station, use to the “Manual tuning” operation.

• When in the auto tuning mode on the FM band, the “STEREO” indicator lights on the display when a stereo broadcast is tuned in. At open frequencies, the noise is muted and the “TUNED” and “STEREO” indicators turn off.

65