Advanced Setup – Part 1

Setting the Volume Control

Set the upper limit for the volume, the volume level when the power is turned on, and the volume level when the mute mode is set for the each zones.

1 Press the CURSOR D or H button to select “Volume Control” at the “Option Setup” menu, then press the ENTER button.

• The “Volume Control” screen appears.

2 Press the CURSOR D or H button to select the desired setting, then press the CURSOR F or G button to select the parameter.

Volume Limit:

Set the upper limit for the volume for the different zones.

–20 dB, –10 dB, 0 dB:

The volume cannot be increased above the selected levels.

OFF:

If you do not want to set a volume limit, select “OFF”.

In this case, the volume can be set to the AVR- 5805CI’s maximum volume (output) level of +18 dB, which is extremely loud.

Power On Level:

Set the volume that is set when the power is turned on for the different zones.

You can adjust the volume level within the range of –80 to +18 dB in steps of 1.0 dB.

– – – (Mute)

The volume is always muted when the power is turned on.

LAST

The volume set when the AVR-5805CI was last used is stored in the memory and set when the power is turned on.

Mute Level:

Set the volume attenuation level when the mute mode is set for the different zones.

FULL

The volume is fully muted.

–40 dB

The volume is lowered 40 dB from the current level.

–20 dB

The volume is lowered 20 dB from the current level.

Volume Level:

Set whether to fix the output level for the different zones or make it variable.

VAR (variable)

The level can be adjusted freely using buttons on the remote control unit.

–40 dB, 0 dB

The output level is fixed at the set level and the volume can no longer be adjusted.

3

Press the ENTER button to enter the setting.

 

 

• The “Option Setup” menu reappears.

• For ZONE2, ZONE3 and ZONE4 the “Volume Limit” and “Power On Level” can be set when “Variable” is selected for “Volume Level”.

• When the power amplifier is assigned to either of the ZONE2, ZONE3 and ZONE4 channels at “Power Amp Assign”, “–VAR–” (only variable) is displayed and the fixed level cannot be set.

134