Advanced Setup – Part 2

Pressure level with SPL meter at the microphone point.

Adjust AVR volume SPL meter = 80 dB (C)

MIC AMP with mic

AVR-5805CISpeakerMicrophone power supply ex. mixer amp.

Use the internal test tones for mic amp calibration.

120 mVrms

Measure the output level and adjust the mic amp gain to 120 mVrms using a RMS volt meter.

Check the parameter

4

Press the CURSOR D or H button to select “EQ

 

Parameter Check”, then press the ENTER

• The results of the measured items can be checked.

button.

• The EQ parameters that were set in Auto Setup can be

checked.

• The “EQ Parameter Check” screen appears.

• This item is displayed, after the measurement result of the “Auto Setup / Room EQ” is decided.

1 Press the CURSOR D or H button to select “Parameter Check” at the “Auto Setup / Room EQ” menu, then press the ENTER button.

• The “Parameter Check” screen appears.

2 Press the CURSOR D or H button to select the items, then press the ENTER button.

• The verification screen appears.

3 If the check ends, press the ENTER button again.

151