Check of the measurement result

• The results of the measured items can be checked.

1 Press the CURSOR D or H button to select items, then press the ENTER button.

• Switch to the verification screen. Example: Speaker Config. Check

Easy Setup and Operation

5 Press the CURSOR F button.

• After the data is stored, the “Auto Setup / Room EQ” menu appears automatically.

• Sometimes due to the electrical complexities of subwoofers and the interaction with the room, THX recommends setting the level and the distance of the subwoofer manually.

• Sometimes due to interaction with the room, you may notice irregular results when setting the level and/or distance of the main speakers. If this happens, THX recommends setting them manually.

• Please note that any THX main speakers should be set to Small (80 Hz). If you set up your speakers using Auto Setup, please make sure manually that any THX speakers are set to Small with 80 Hz crossover.

[ First screen ]

2 Press the ENTER button.

• Switch to the second screen.

Example: Speaker Config. Check

[ Second screen ]

3 If the check ends, press the ENTER button again.

4 Press the CURSOR D or H button to select whether or not to save the data you have checked.

Store:

Set with the checked measurement value.

All parameters are stored up.

Cancel:

Cancel the auto setup settings.

When measurements have been made using the measurement microphone, speakers with a built-in filter such as subwoofers might be set with a value that differs from the physical distance because of the internal electrical delay.

If the “Channel Setup” or “Power Amplifier Assignment” settings are changed after completing the auto setup, perform the auto setup procedure again. In the same way, if the speaker layout has been changed, we recommended performing the auto setup procedure over again.

NOTE:

Do not turn off the power while the data is being stored. If the power is turned off while the data is being stored, the Room EQ parameters stored in the memory will be cleared, and it will not be possible to select “Audyssey”, “Front” or “Flat” equalizer settings.

25