To reset the input function name to the default value, press the CURSOR F or G button to highlight the input function display, then press the CURSOR H button.

When “Default Yes” is selected, then press the CURSOR F button to reset to the default input function name.

 

 

Once all the characters have been input, press

5 the ENTER button.

 

 

• The “Function Rename” screen reappears.

 

 

Use the same procedure to change other input

 

 

function names as well.

 

 

 

6

Press the ENTER button to enter the setting.

 

 

 

 

• The “Audio Input Setup” menu reappears.

Advanced Setup – Part 1

Setting the IEEE1394 Assignment

Assign the device connected by IEEE1394 cable to an input source. The power of the device to be assigned must be turned on ahead of time.

1 Press the CURSOR D or H button to select “IEEE1394 Assign” at the “Audio Input Setup” menu, then press the ENTER button.

• The “IEEE1394 Assign” screen appears.

2 Press the CURSOR D or H button to select the device to be assigned to the input source, then press the CURSOR F or G button to select the input source.

When the input function is selected, the display is as shown below.

Example: When the name has been changed to “DVD- 5910”

3

Press the ENTER button to enter the setting.

• The “Audio Input Setup” menu reappears.

If you do not wish to assign the device connected by IEEE1394 cable to an input source, the IEEE1394 input can be selected by turning the FUNCTION knob. In this case, the connection information is cleared when the power of the connected device or the AVR-5805CI is turned off, so the selection procedure must be performed again.

By default, if no device has been connected using an IEEE1394 cable in the past, “No Connection” is displayed.

“Connection Change” is displayed if there is a change in the IEEE1394 connection status while this screen is displayed.

If the model name cannot be acquired from the connected IEEE1394 device, “UNKNOWN” is displayed.

If an IEEE1394 device other than one for IEEE1394 audio playback is connected, “Not Play” is displayed and the input source cannot be assigned.

107