Turning the sound off temporarily (MUTING)

• Use this to mute the audio output temporarily.

Press the MUTE button.

You can adjust the muting level ( page 134).

Cancelling MUTING mode:

Press the MUTE button again, or press the MASTER VOLUME button on the remote control, or adjust the volume up or down via the front panel MASTER VOLUME knob.

Listening over headphonesConnect the headphone to the PHONES jack.

The pre-out output (including the speaker output) is automatically turned off when headphones are connected.

NOTE:

To prevent hearing loss, be careful not to raise the volume level excessively when using headphones.

Switching the surround speakersPress the SPEAKER button.

The surround speakers switch as shown below each time the SPEAKER button is pressed.

SURROUND ASURROUND B

SURROUND A+B

This operation is possible when the setting for using both surround speakers A and B is made at “Speaker

Configuration” ( page 140, 141).

Switching between HDMI and DVI-D monitor output

The monitor out terminal switch as shown below each time the MONITOR SELECT button is pressed.

HDMI DVI

Basic Operation

Selection of resolution setting (SCALE)Press the SCALE button.

The resolution switches as follws each time the SCALE button is pressed.

• When “HDMI” is selected for the “Scaler” setting:

480p/576p

 

1080i

 

720p

 

 

Through 1080p

• When “Component” is selected for the “Scaler” setting:

480p/576p

 

1080i

 

720p

 

 

Through

When the SCALE button is pressed, the current setting is shown on the display. If the SCALE button is pressed while the current setting is displayed, the “Resolution” setting can be changed.

For description of the each resolution settings, see page 113 to 114.

Combining the currently playing sound with the desired image (VIDEO SELECT)Press the VIDEO SELECT button until the desired image appears.

D V D

V I D E O S O U R C E

The video source selected with the video select function is stored in the memory for the different input sources.

Cancelling simulcast playback:

Select the “SOURCE” pressing the VIDEO SELECT button.

It is not possible to select HDMI and DVI input signals.

When playing HDMI/DVI video input signals, the analog video signal of another function cannot be selected for the HDMI video output.

If the VIDEO SELECT mode is used during playback in the XM or Network Audio, the picture switches to the picture selected from the control panel display.

Cancel the VIDEO SELECT mode if you want to display the control panel.

Video on/off

When no video signals of a DVD, etc., are connected to the AVR-5805CI and the DVD, etc., are connected directly to a TV, etc., the unneeded video circuitry can be turned off by selecting the “VIDEO OFF” setting.

Press the VIDEO ON/OFF button.

45