10.4.1TCP/IP Config.

There are a series of choices that can be selected to configure FastPort on a TCP/IP networks. The following is a hierarchy of the choices that can be selected. To open each selection, use the mouse and follow the arrows to the sub-menus.

Figure 10-8. TCP/IP Config. Select

Note: The latest version of FastManage has an improved TCP/IP Config. screen. Contact Digi’s LAN technical support for information pertaining to early versions of FastManage and the TCP/IP Config. screen.

From TCP/IP Config., selections include:

IP Configuration->IPAddress Properties: Enables a user to change a variety of IP options. Changes take effect at system reset. Options for this menu include (Figure 10-9):

DHCP Enable: Enables the DHCP feature. Default: Enabled.

DHCP Disable: Disables the DHCP feature.

IP Address: Changes the IP address of a device (e.g., if a device is moved to a different subnet).

Subnet Mask: Sets the subnet mask address for the device. If no IP address is set, then default is 0.0.0.0. If an IP address is set, then:

For Class A addresses, default is 255.0.0.0

For Class B addresses, default is 255.255.0.0.

For Class C addresses, default is 255.255.255.0

Gateway Address: Sets up the address of the router that routes IP packets across subnets. Default is 0.0.0.0.

Figure 10-9. Configure IP Address Properties Screen

MIL-3000FTX Series of FastPort Print Servers

10-5

Page 104
Image 104
Digi MIL-3000FTX manual 10.4.1TCP/IP Config, From TCP/IP Config., selections include