Digi MIL-3000FTX Resetting FastPort to Factory Defaults, Resetting by Toggling the DIP Switches

Appendix A

Resetting FastPort to Factory Defaults

A.1 Resetting by Toggling the DIP Switches

Note: This will also reset the IP Address back to 0.0.0.0.

1. Place all the front panel switches down.

Note: Unplug then plug back in the power supply.

2.Wait at least 4 seconds.

3.Toggle switches D4 up and down quickly at least 10 times.

4.Reset switches back into normal printing mode.

5.Power cycle the unit.

A.2 Resetting by Console Option

1.Establish a serial, telnet, or NetBIOS console monitor to obtain the Options menu (or Available Command menu)

2.In the Options menu, press [Z] (option Z) to reset the unit.

Note: An option to reset the IP address appears. Select to do so.

3.After NVRAM write is done, press [R] to end the console session and reset FastPort.

A.3 Hardware Features

•The MIL-3000FTX board, with Ethernet controller, serial, and parallel port interfaces

•CPU: An 80186 processor, with a 16 MHz clock

•Memory: 256K RAM

•Flash: Flash device is 29F040. It is a 4 Mbps EEPROM and arranged in 2 ⋅ 256k ⋅ 8 format.

•MAC chipsets: Ethernet controller is 10/100 Mbps, with its own memory management

•10/100BASE-TX, RJ-45 (unshielded twisted pair) connector

MIL-3000FTX Series of FastPort Print Servers A-1