Digi MIL-3000FTX Installing FastManage, IP Configuration, IPX Configuration, NetBIOS Configuration

8.1.3IP Configuration

1.Load Packet or ODI drivers for the NIC card

2.Add the following line to the net.cfg file for ODI Drivers:

Frame Ethernet_II

8.1.4IPX Configuration

•Novell 4.1 Drivers for Windows and DOS. Refer to the Novell Netware Documentation for information

•ODI Driver for the network interface card loaded

8.1.5NetBIOS Configuration

NetBIOS over NetBEUI network configuration for Win 3.11 and/or Win 95.

8.2 Installing FastManage

There are two different modes of installation:

•Express installation

•Custom installation

8.2.1Express Installation

Express install is the fastest way of setting up the FastManage software and is recommended for first time users. For detailed installation, go to “Custom Installation” on page 8-3. Do the following to install FastManage:

1.From “Start” (or “File”), select Run.

2.Type d:setup.exe (or the drive where the CD-ROM is located) on the command line and click OK.

3.Register FastManage and click Next.

4.Confirm that the registration is correct and click Yes.

5.Choose the type of installation. In this case, select Express Install (for first-time installation) and click Next.

Note: Go to Section 8.2.2 for Custom Installation (or Advanced) instructions.

6. Choose a network protocol: IP, IPX, or NetBIOS

Note: IPX requires Novell 4.1 DOS and Windows drivers already installed on the system.

MIL-3000FTX Series of FastPort Print Servers 8-2