Digi MIL-3000FTX manual 10.4.3General Config, 10.4.4Ethertalk Config

-->Preferred DS Context: Sets the “context” where FastPort’s server/ queues are defined. The name entered must be a valid “Tree” or “Context. The field is blank by default.

•Print Server Config.-->Queue Scan Rate: Sets the rate (times per second) that FastPort scans the Novell queue for print jobs (valid numbers are between 1- 6). Default: 1.

-->Frame Type: Selects NetWare’s frame type. Default: Autosensing.

-->Configuration Server: Is the server where FastPort’s bindery configuration file resides. The field blank by default.

-->Notification: Enabling this parameter allows FastPort to send status to

users on the Notify list Default: Disabled.

10.4.3General Config.

There are a series of choices that can be selected to configure FastPort for a general network, including:

•Community Strings: Sets SNMP community strings. Default for “Get Community String” is public. Default for “Set Community String” is private.

•Flash Config. -->Allow download: Allow/disallow the upgrade of the Firmware. Default:

Allow.

10.4.4Ethertalk Config.

There are a series of choices that can be select to configure FastPort for a Ethertalk network, including:

Figure 10-11. Ethertalk Config. Selections

From Ethertalk Config., selections include:

•General Config.--> Zone Name: Logical group where FastPort exists.

-->Enable Ethertalk: Enables/disables the Ethertalk protocol. Default: Disabled.

-->Ethertalk Phase: Sets the compatibility level of the Appletalk network

system. Default: Phase 2.

•Parallel Printer Setup-->Printer 1: This selection sets printer 1 port’s parameters. -->Printer 2 (optional): Sets printer 2 port’s parameters.

-->Printer 3 (optional): Sets printer 3 port’s parameters.

Note: The number of printers to configure depends on the number of parallel ports on the FastPort.

MIL-3000FTX Series of FastPort Print Servers 10-7