Digi MIL-3000FTX manual 10.4.2Novell Config, From Novell Config., selections include

•FPFILTER Configuration-->Enable FPFILTER: Enables host software services. Default:

Enabled.

-->Auxiliary ports: Specifies the auxiliary ports for the parallel and serial port printing. Default is 0 for each port.

Note: The number of auxiliary ports to configure depends on the number of serial and parallel ports on the FastPort.

•LPD Configuration: Enables BSD-type LPD print services and its options. Default: All are

Enabled.

•Restricted Hosts: -->Subnets: Limits access to FastPort. Only hosts in the selected subnet can access FastPort. Default for “Subnet” and “Mask” is 0.0.0.0. -->Allowed IP Addresses: Limits access to FastPort. Only the hosts with the IP addresses can access FastPort. Default for all four fields is 0.0.0.0.

10.4.2Novell Config.

There are a series of choices that can be selected to configure FastPort for a Novell network, including:

Figure 10-10. Novell Config. Selections (Windows ‘95)

From Novell Config., selections include:

•IPX Config. -->IPX SAP Name: Changes the name used by the device in service messages on the IPX network. This name displays in Map 1 of the Discovery Application node. Default: FPXXXXXX, where “XXXXXX” is a the last six digits of the MAC address.

-->IPX SAP Interval: Configuring the SAP internal of the device (numbers

are between 1-6). Default: 1.

-->IPXTraps-->Enable IPX Traps: When enabled, the software sends “traps” to a designated system. Default: Enabled. For more information on traps, refer to “Traps” on page 2 and “IPX Trap Hosts” (next selection).

-->IPX Trap Hosts: Designates to the system where traps will be sent. Default for both “IPX Trap Host 1” and “IPX Trap Host 2” are all zeros.

-->IPX Enabled: Enables/disables IPX protocol. Default: Enabled.

•NDS Config. -->Enable NDS: Enables/disables NetWare Directory Services. Default:

Enabled.

-->Preferred DS Tree: Sets the “tree” where FastPort’s server and print queues are defined. The name entered must be a valid “Tree” or “Context.” The field is blank by default.

MIL-3000FTX Series of FastPort Print Servers 10-6