Digi MIL-3000FTX manual Showprn.exe -d1, D1 or -d2 or -d3, etc, Nbmon.exe FP0F0FBA

Group	Server	Service	Status
Workgroups	FP0F0FBA	Parallel1	No active parallel job

Note: If an error message “0x23 error with add name” appears, this means the NetBEUI stack is not configured correctly. If showprn.exe did not return a list of printers, or if it returned with an error, try executing the utility again. This time with a special option that tells the utility to try a different “logical LAN layer”:

showprn.exe -d1

If a Windows-based system has multiple protocols and/or multiple network interfaces, a user needs to specify the LAN layer, by typing:

-d1 or -d2 or -d3, etc...

3.Once showprn.exe displays FastPort, the nbmon utility can be used to connect and modify settings. Using the example above, type in the following line:

nbmon.exe FP0F0FBA

Note: If the -d1 or -d2 option was used with showprn.exe, you will need to type that -d1 or -d2 option on the nbmon.exe command line as well.

If the connection is successful, the following is displayed:

v.1.0.102

Press <ESC> to exit

Ver 6.1 Build 18, Datecode 10/23/1998 18:50 Type “S” to see current status

Type “D” to see current configuration Type “!” to enter monitor

Type “A” to abort connection

FastPort is now connected. If the above information does not appear, re- check the switches and LEDS. Contact Digi’s LAN technical support if necessary.

4.Type [!] and then press [return].

5.Type in [Y] for yes to enter monitor.

6.A a list of options appear:

Command [?, C, D, E, F,...., Z]: -->

Type in the command to set the IP address: [I]

7.A display of current IP address appear. Type [Y] for yes to modify this address.

MIL-3000FTX Series of FastPort Print Servers 2-9