Digi MIL-3000FTX manual 1.3Using Setup Font List, Option Choice Description Serial Port Parameters

Table 6-5: Option (Default is in Parenthesis)

Option	Choice	Description
	Serial Port Parameters
Type	(No Binary) or Binary	Serial type is based on the traffic type and whether or not the port is
	adobe or Binary hp	handling Binary PostScript.
Stop bits	(1) or 2	Number of stop bits required.
Speed	300,600,1200,4800,(9600),	Transmission speed (in bps).
	19200, 38400
Parity	Yes or (No)	Use of parity bit checking.
Xon	(Yes) or No	Use of Xon/Xoff for flow control.
	Network Protocols Enabled
Sockets	(Yes) or No
LPD	(Yes) or No
NetWare	(Yes) or No
EtherTalk	(Yes) or No
		Operational Parameters
Reset the Print	Yes or (No)	Forces the print server to reboot when FastPort is power cycled.
Server
Set IP address	Set IP Address (0.0.0.0)	Use to specify an IP address for FastPort using dotted-decimal format.
Reset NVRAM	Yes or (No)	Forces NVRAM values to be returned to their defaults when FastPort is
to defaults		power cycled.
	Parallel Port Parameters
Enable Bi-direct.	Yes or (No)	Enables bi-directional printing (see chapter 11)
Interface

6.4.1.3Using Setup Font List

FastPort can be told the fonts available for printers connected to the parallel port. If the printer fonts do not match the defaults, download a modified Font List file to the FastPort.

1.Locate the Setup Font List file in the “Advanced Utilities” or “FastPort Utilities” folder.

2.Double-click on the Setup Font List icon.

3.Edit the list of fonts to match your printer’s.

4.Save the list and quit “TeachText.”

5.Open the LaserWriter Utility.

6.Select Download PostScript File from “Utilities.”

7.Select the file Setup Font List. When the file completes downloading, quit the utility.

The font list remains in FastPort’s memory until it restarted.

Note: The font list for the serial port of FastPort does not need to be changed.

MIL-3000FTX Series of FastPort Print Servers 6-5