Digi MIL-3000FTX manual file map.map, 2.2Discovery Parameters

•Save Maps On Exit: If this parameter is selected, the software saves the Map when Discovery Application is exited. Checked by default.

•Save Parameters On Exit: If selected, this option saves preferences when Discovery is exited. Checked by default.

•Refresh every: This selection “refreshes” the Map every <n>

seconds. Default: 60 seconds.

•Discover: This selection “re-discovers” hosts every <n> seconds.

Default: 90 seconds.

•Dead: This selection is the number of attempts the software makes

before marking the node as “dead.” Default: 2.

•Wait: This selection signifies the amount of time the software waits for

a reply from a node. Default: 1 second.

•Default Map: This selection will enter the name of the default Map

file: map.map.

•Map File: This selection will enter the path for the Map files. Default: c:\fm.

•Hosts File: This selection enters the path for the host file. Default:

C:\ETC.

•Bootptab File Path: This selection enters the path for the bootptab

file. Default: C:\FM.

•Allow To Edit “Hosts” File: If selected, Discovery updates the “hosts” file if a new host file is discovered. Checked by default.

•Default: Initialize all the parameters to default values.

•Save Options: Saves all changes to the issnmp.ini file.

•Cancel: Cancels the changes.

8.2.2.2Discovery Parameters

The “Discovery Parameters” menu (Figure 8-4) configures the parameters used for the discovery nodes (Chapter 9). The following section gives information about the discovery.

•Enable IP: When selected, this enables IP protocol. If not selected, FastManage will not perform any SNMP over IP operation. Checked by default.

MIL-3000FTX Series of FastPort Print Servers 8-5