Digi MIL-3000FTX manual Install Script on IBM RS/6000, Choose Option #2. qdaemon-based systems

–Whether or not the IP information about FastPort has been entered into the host naming method

–Ethernet address (on the bottom of the device)

–IP address given FastPort

–The method for assigning FastPort its IP address

5.The main menu appears, select Option #2, Install a printer or plotter. The software prompts for:

–Method of installation. Either LPD or host software

–Hostname or IP address for FastPort

–Printer name of the device (may be same as hostname)

–Type of printer (PCL, PostScript, or ASCII)

–Printer is connected to the serial or parallel port

–Type of banner page

5.3.3Install Script on IBM RS/6000

Use the install.sh to install FastPort on an IBM AIX system. This modifies the /etc/gconfig file to add a printer entry and specifies using rembak for remote spooling, To install:

1.If not already done so, load the install.sh software.

2.Type: ./install.sh to run the install script.

3.Select a FastPort by its model number.

4.Choose Option #2. qdaemon-based systems.

5.If not already done so, assign an IP address to FastPort by selecting

Option 1, Configure a Fastport.

6. Choose Option #3, install a Printer or Plotter. Enter:

–Hostname of FastPort

–Queue name to create

–Directory for the back end script

–Directory to load the host software

–Host naming method

–Type of data sent to the printer (ASCII, Graphics, PS or PCL)

MIL-3000FTX Series of FastPort Print Servers 5-3