Digi MIL-3000FTX manual Advanced Configuration Menu in ACT, Requirements, Setup, Navigating in ACT

•Resetting FastPort’s NVRAM of to factory defaults

•Choosing a primary NetWare server

•Enabling/disabling protocols (e.g., TCP/IP, EtherTalk, etc.)

•Customizing LPD

C.1.3 Requirements

•A MIL-3XXX FastPort print server with firmware release 4.5.x (and above) installed.

•NetWare file server with the PC logged into the server.

•NetWare enabled (i.e., NetWare drivers are loaded).

•Supervisor access to an object is required for some features.

C.1.4 Setup

1.Create a directory for the software (e.g., type md Digi and press [Enter]. Where Digi is the directory’s name).

2.From the utility driver, copy the file ACT.EXE onto the recently created directory. From C:\Digi>, type copy a:\ and press [Enter].

C.1.5 Navigating in ACT

From the appropriate directory (e.g., c:\Digi), enter ACT.

1.Type ACT and press [Enter].

2.Select a device or a menu option by:

a.Using arrow keys, highlight an item and press [Enter].

b.Use a hot key, usually the first letter in the menu option.

3.To exit out of a menu or option, press [Esc].

4.Highlight the designated field and press [Enter]. To leave ACT, select the Exit menu.

C.2 Advanced Configuration Menu in ACT

The Advanced Configuration menu has five major submenus:

•NetWare Configuration: Controls NetWare-specific print server parameters.

MIL-3000FTX Series of FastPort Print Servers C-2