Digi MIL-3000FTX Display Summary Configuration Parameters, Including, Display/Set Ethernet Options

G.3 D—Display Summary Configuration Parameters, Including

Command [?,C,D,E,F,H,I,L,N,P,Q,R,S,Z,*,+] --> d
FastPort Model 3200X
Firmware revision 6.1.18, Datecode 10.23.1998 18:50
Ethernet address:00 40 C8 00 0B 0B
IP address:0.0.0.0
AUI Network module installed.
Console status monitoring: Off
Network monitor password security: Off
Sockets (fpfilter) enabled.
LPD enabled.
Netware enabled.
Microsoft Windows print services.
HP DLC enabled.
AppleTalk enabled.
Parallel port 1 mode: Standard
Parallel port 2 mode: Standard
Serial port 1 config: Baud	Data	Stop	Parity	Flow
9600	8	1	None	Xon/Xoff
Serial port 2 config:Baud	Data	Stop	Parity	Flow
9600	8	1	None	Xon/Xoff

(type “N” in monitor to view the network protocol parameters)

G.4 E—Display/Set Ethernet Options

Note: Aux port is now set in the sockets section of the Network protocols menu)

Link test is currently enabled. Link test: 1.(disabled)

2.(enabled)

<enter> (don't change/continue)

Link test is now enabled

G.5 F—Flash Firmware Load Enable/Disable

Flash load is enabled.

•This Bank: Vers. 6.1.15, Datecode 12/2/1997 13:25, (in Bank #1, seqNum=10)

•Other Bank: Vers. 6.0.29, Datecode 2/25/1997 12:20, (in Bank #0, seqNum=9)

Flash load currently is enabled. Disable, yes or no (y or n)?:n

Special Options for Flash Code Image Control:

1.(Restart Running Image in Other Bank)

2.(Copy This Image into Other Bank)

MIL-3000FTX Series of FastPort Print Servers G-2