7.Specify the system’s IP address and its subnet mask. The gateway selection is optional (Figure 8-1).

Figure 8-1. IP Parameters

8.Choose a location to install the FastManage application and click Next. Default is c:\fm.

9.A message appears asking if a menu item for FastManage is to be added to the “NWADMIN” utility. Select Yes and snap-fp.dllfile is copied to the Windows directory and the nwadmin.ini file is updated.

10.Choose to have the system rebooted and click Finish.

8.2.2Custom Installation

Custom installation configures the Discovery and/or SNMP parameters. Custom install follows the same procedure as the express, except for a extra steps. To begin custom installation:

7.After step 6 in section 8.2.1, choose Custom Installation and click

Next.

8.Choose a network protocol: IP, IPX or NetBIOS.

9.If IP was selected, specify the system’s IP address and its subnet mask. The gateway selection is optional.

10.In the “Configure Advanced Parameters” menu (Figure 8-2), configure the following:

General Parameters and click Next. Refer to section 8.2.2.1 to configure the general parameters.

Discovery Parameters and click Next. Refer to section 8.2.2.2 to configure the discovery parameters.

SNMP Agent Parameters and click Next.Refer to section 8.2.2.3 to configure the SNMP agent parameters.

MIL-3000FTX Series of FastPort Print Servers

8-3

Page 82
Image 82
Digi MIL-3000FTX manual Custom Installation, IP Parameters