Enterasys Networks RBT-4102 manual Using the CLI to Configure Virtual APs, Examples

Radio Interface

Using the CLI to Configure Virtual APs

From the global configuration mode, enter the interface wireless a command to access the 802.11a radio interface, or the interface wireless g command to access the 802.11g radio interface. Use the vap [1‐7] command to specify the VAP you want to configure and to enter VAP mode. Set the VAP SSID using the ssid command and, if required, configure a name for the VAP using the description command. Use the native‐vlanid command to specify the native VLANID for this VAP. Enable secure access for this VAP with the secure‐access command. Set any other parameters as required. Specify whether clients associated with this VAP can establish wireless communications with each other through the AP with the ibss‐relay command. Specify the maximum number of clients that can associate with the VAP using the max‐association command.

Examples

RoamAbout 4102#configure

Enter configuration commands, one per line. End with CTRL/Z

RoamAbout 4102(config)#interface wireless g

Enter Wireless configuration commands, one per line.

RoamAbout 4102(if-wireless g)#vap 1

RoamAbout 4102(if-wireless g: VAP[1])#ssid r&d-a-V1

RoamAbout 4102(if-wireless g: VAP[1])#des AP-a-V1

RoamAbout 4102(if-wireless g: VAP[1])#native-vlanid 20

RoamAbout 4102(if-wireless g: VAP[1])#secure-access

RoamAbout 4102(if-wireless g: VAP[1])#ibss-relay

RoamAbout 4102(if-wireless g: VAP[1])#max-association 32

RoamAbout 4102(if-wireless g: VAP[1])#exit

RoamAbout 4102#

RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-75