Initial Setup Using the CLI
b.Click the DHCP Client: Disable radio button. DHCP allows you to enable or disable the option to obtain the IP settings for the access point from a DHCP (Dynamic Host Configuration Protocol) server. The IP address, subnet mask, default gateway, and Domain Name Server (DNS) address are dynamically assigned to the access point by the network DHCP server. Default: Enable
c.Specify the IP Address, Subnet Mask, Default Gateway, and Primary and Secondary DNS.
Note: Enterasys Networks recommends that you reset the access point after changing the DHCP client status.
‐IP Address is the IP address of the access point. Valid IP addresses consist of four decimal numbers, 0 to 255, separated by periods.
‐Subnet Mask is the mask that identifies the host address bits used for routing to specific subnets.
‐Default Gateway is the IP address of the router for the access point, which is used if the requested destination address is not on the local subnet.
If you have management stations, DNS, RADIUS, or other network servers located on another subnet, type the IP address of the default gateway router in the text field provided. Otherwise, leave the address as all zeros (0.0.0.0).
d.Click Apply at the bottom of the page.
The access point displays a Settings Saved message.
e.Click OK.
