Enterasys Networks RBT-4102 manual CLI Commands for Filtering

Filter Control and VLANs

CLI Commands for Filtering

Use the filter ibss‐relay command from the global configuration to set the mode for wireless‐to‐ wireless communications through the access point. Use the filter wireless‐ap‐manage command to restrict management access from wireless clients. Use the iapp or no iapp commands to enable or disable clients from roaming between access points.

To configure Ethernet protocol filtering, use the filter ethernet‐type filter enable command to enable filtering and the filter ethernet‐type protocol <protocol> command to define the protocols that you want to filter. To remove a protocol filter from the table, use the no filter ethernet‐type protocol <protocol> command. To display the current settings, use the show filters command from the Executive mode.

Example

RoamAbout 4102#configure

Enter configuration commands, one per line. End with CTRL/Z

RoamAbout 4102(config)#filter wireless-ap-manage

RoamAbout 4102(config)#filter ethernet-type enable

RoamAbout 4102(config)#filter ethernet-type protocol CDP

RoamAbout 4102(config)#exit

RoamAbout 4102#show filters

Protocol Filter Information

===========================================================

IBSS Relay Control	:All VAP Mode	802.11b/g VAP0 :ENABLED
802.11a VAP0	:ENABLED
VAP1	:ENABLED	VAP1 :ENABLED
VAP2	:ENABLED	VAP2 :ENABLED
VAP3	:ENABLED	VAP3 :ENABLED
VAP4	:ENABLED	VAP4 :ENABLED
VAP5	:ENABLED	VAP5 :ENABLED
VAP6	:ENABLED	VAP6 :ENABLED
VAP7	:ENABLED	VAP7 :ENABLED
Wireless AP Management	:ENABLED
Ethernet Type Filter	:ENABLED

Enabled Protocol Filters

-----------------------------------------------------------

Protocol: CDP ISO: 0x2000

===========================================================

RoamAbout 4102#

4-22 Advanced Configuration