Enterasys Networks RBT-4102 manual WDS and STP, Advanced Configuration

WDS and STP

WDS and STP

Each access point radio interface can be configured to operate in a bridge mode, which allows it to forward traffic directly to other access point units. To set up bridge links between access point units, you must configure the Wireless Distribution System (WDS) forwarding table by specifying the wireless MAC address of all units to which you want to forward traffic. You can specify up to eight WDS bridge links for each unit in the wireless bridge network.

The Spanning Tree Protocol (STP) can be used to detect and disable network loops, and to provide backup links between bridges. This allows a wireless bridge to interact with other bridging devices (that is, an STP‐compliant switch, bridge or router) in your network to ensure that only one route exists between any two stations on the network, and provide backup links which automatically take over when a primary link goes down.

4-50 Advanced Configuration