Enterasys Networks RBT-4102 manual c. Reboot the RoamAbout RBT‐4102

Initial Setup Using the CLI

RICO, QA-QATAR, RO-ROMANIA, RU-RUSSIA, SA-SAUDI ARABIA, SG-SINGAPORE, SK-SLOVAK REPUBLIC, SI-SLOVENIA, ZA-SOUTH AFRICA, ES-SPAIN, SE-SWEDEN, CH-SWITZERLAND, SY-SYRIA, TW-TAIWAN, TH-THAILAND, TT-TRINIDAD & TOBAGO, TN-TUNISIA, TR-TURKEY, UA-UKRAINE, AE-UNITED ARAB EMIRATES, GB-UNITED KINGDOM, UY-URUGUAY, UZ-UZBEKISTAN, VE-VENEZUELA, VN-VIETNAM, YE-YEMEN,

ZW-ZIMBABWE

b.Determine the code for your country, and then type country followed by your country code (for example, country SG for Singapore).

c.Reboot the RoamAbout RBT‐4102.

RoamAbout 4102#country SG

Please reset the AP to make the country code change effective RoamAbout 4102#reset board

Reboot system now? <y/n>: y

3.If your access point uses a DHCP assigned IP address, go to Step 4 to change the default username and password.

Otherwise, disable DHCP for this access point as follows:

a.Type configure to enter configuration mode.

b.Type interface ethernet to access the Ethernet interface configuration mode.

RoamAbout 4102#configure

Enter configuration commands, one per line. End with CTRL/Z RoamAbout 4102(config)#interface ethernet

Enter Ethernet configuration commands, one per line. RoamAbout 4102(if-ethernet)#

c.Enter no ip dhcp to disable DHCP.

RoamAbout 4102(if-ethernet)#no ip dhcp

DHCP client state has changed. Please reset AP for change to take effect. RoamAbout 4102(if-ethernet)#exit

RoamAbout 4102#reset board Reboot system now? <y/n>: y Username: admin Password:******** RoamAbout 4102#configure

Enter configuration commands, one per line. End with CTRL/Z RoamAbout 4102(config)#interface ethernet

Enter Ethernet configuration commands, one per line. RoamAbout 4102(if-ethernet)#

d.Set the IP Address. Type ip address ip‐address netmask gateway, where ip‐address is the access point’s IP address, netmask is the network mask for the network, and gateway is the default gateway router. Check with your system administrator to obtain an IP address that is compatible with your network.

RoamAbout 4102(if-ethernet)#ip address ip-address netmask gateway RoamAbout 4102(if-ethernet)#end

RoamAbout 4102(config)#

After configuring the access point’s IP parameters, you can access the management interface from anywhere within the attached network. The command line interface can also be accessed using Telnet from any computer attached to the network.

e.Go to Step 4.

RoamAbout RBT-4102 Wireless Access Point Configuration Guide 3-3