TCP / IP Settings

Untagged VlanId

: 1

========================================

RoamAbout 4102#

SSH Configuration

To enable the SSH server, use the ip ssh‐server enable command from the CLI Ethernet interface configuration mode. To set the SSH server UDP port, use the ip ssh‐server port command. To disable the Telnet server, use the no ip telnet‐server command. To view the current settings, use the show system command from the CLI Executive mode (not shown in the following example).

Example

RoamAbout 4102#configure

Enter configuration commands, one per line. End with CTRL/Z

RoamAbout 4102(config)#interface ethernet

Enter Ethernet configuration commands, one per line.

RoamAbout 4102(if-ethernet)# ip-ssh-server enable

RoamAbout 4102(if-ethernet)# ip-ssh-server port 1124

RoamAbout 4102(if-ethernet)# no ip telnet-server

Ethernet Settings Configuration

To enable or disable auto‐negotiation on the Ethernet port, use the auto‐negotiate enable or auto‐negotiate disable commands, respectively, as shown in the example below.

Note: If the Ethernet port negotiation state is disabled, you must set the port speed and duplex by using the 'speed-duplex' command.

Example

test4102#configure

Enter configuration commands, one per line. End with CTRL/Z test4102(config)#int eth

Enter Ethernet configuration commands, one per line. test4102(if-ethernet)#auto-negotiate disable test4102(if-ethernet)#speed-duplex ?

10MF Set speed/duplex to 10Base-T Full Duplex 10MH Set speed/duplex to 10Base-T Half Duplex 100MF Set speed/duplex to 100Base-TX Full Duplex 100MH Set speed/duplex to 100Base-TX Half Duplex

test4102(if-ethernet)#speed-duplex 100MF

Example

test4102(if-ethernet)#show

Ethernet Interface Information

========================================

IP Address

: 192.168.20.55

Subnet Mask

: 255.255.255.0

Default Gateway

: 192.168.20.2

Primary DNS

: 192.168.20.151

Secondary DNS

: 128.100.56.135

Admin status

: Up

Operational status

: Up

Untagged VlanId

: 1

RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-9

Page 45
Image 45
Enterasys Networks RBT-4102 manual SSH Configuration, Ethernet Settings Configuration