HP 5000 manual Turn Drive Roller, Detected, the message below is displayed

Service Tests and Utilities

T R O P P U S E N O H P

Turn DRIVE ROLLER

The purpose of this Service Utility is to rotate the Overdrive, Drive Roller and Roller Mark in order to clean them.

NOTE	Remove the media before performing this operation. If media is
	detected, the message below is displayed.
	1.1 Turn DRIVE ROLLER
	Please remove media
	completely
	Press ENTER to continue

Perform the Turn DRIVE ROLLER utility as follows:

1.Lift the Window on the printer and deactivate the Window Sensor by inserting a pencil in the Sensor slot on the top of the Right Trim.

2.In the Service Utilities submenu, scroll to "Turn DRIVE ROLLER" and press Enter.

1.Service Utilities

1.1Turn DRIVE ROLLER

1.2Prime TUBES

1.3Altitude Setup

1.4EEROM Setup

1.5Reset Life Counters

1.6Backup EEROM

Top
Back
↑	Make Selection
↓
		Press Enter
Enter

3.Once the utility starts, the Drive Roller will begin to turn slowly and the following message will be displayed. Everytime the Drive Roller completes a turn, the counter will increase by one.

Cancel

1.1Turn DRIVE ROLLER

1 turn (s)

Press Cancel

Press CANCEL to stop

4.If you want to stop the Drive Roller from turning, press Cancel and the following message will appear on the front panel. Press Enter if you want to return to the Service Utility menu or press Back if you want to continue turning the Drive Roller.

1.1Turn DRIVE ROLLER Stopped!

Press ENTER to exit or BACK to resume

Top

Back

↑

↓

Enter

Make Selection

4-18 HP DesignJet 5000 Series Printers Service Manual