HP 5000 manual EMC Covers, Removal

Removal and Installation

EMC Covers

Removal

WARNING

NOTE

NOTE

Switch off the Printer and remove the Power Cord.

Refer to the table on Page 8-4for information on screw types.

The EMC Cover is composed of three parts; Top, Lower Left and Lower Right. Procedures below describe removal of the EMC Covers as; one assembly, the Top only, the Lower Right only. The procedure you select depends on the part you want to access.

EMC Covers as one assembly

1.Remove the Top Cover - Refer to Page 8-5.

2.Remove the Back Cover - Refer to Page 8-23.

3.Remove Right Rear Cover - Refer to Page 8-16.

4.Remove Left Rear Cover - Refer to Page 8-15.

5.Remove Electronics Module - Refer to Page 8-92.

6.Disconnect connector from Ink Leak Detector and remove 1 T-15 screw (Type B) to remove Ink Leak Detector

cable clamp.

8-32 HP DesignJet 5000 Series Printers Service Manual