HP 5000 manual Prime Tubes

Service Tests and Utilities

T R O P P U S E N O H P

Prime TUBES

The purpose of this Service Utility is to prime the Tubes when a new Tubes System has been installed or automatic priming was not completed.

NOTE

If you are using this Service Utility because automatic priming has failed, you will need to remove the Setup Printheads used and insert new Setup Printheads.

NOTE	Check there is enough ink remaining in the Ink Cartridges
	before starting to prime the tubes; if the ink level is LOW or
	VERY LOW, replace the Ink Cartridges.

Prime the TUBES as follows:

1.In the Service Utilities submenu, scroll to "1.2 Prime TUBES" and press Enter.

1.Service Utilities

1.1Turn DRIVE ROLLER

1.2Prime TUBES

1.3Altitude Setup

1.4EEROM Setup

1.5Reset Life Counters

1.6Backup EEROM

Top
Back
↑	Make Selection
↓
		Press Enter
Enter

2.The following message will be displayed. Press Enter to confirm.

1.2 Prime TUBES

Press ENTER to confirm or BACK to correct

Top
Back
↑
↓
Enter	Press Enter

3.The Printer will begin to startup and in order to continue, press Enter.

Top

INK STARTUP

Printer startup

Press ENTER to Continue

Back
↑
↓
Enter	Press Enter

HP DesignJet 5000 Series Printers Service Manual 4-19