HP 5000 manual Media Sensor

Removal and Installation

Media Sensor

Removal

WARNING	Switch off the Printer and remove the Power Cord.
	1.	Remove the Top Cover - Refer to
		Page 8-5.
	2.	Remove the Right Rear Cover - Refer
		to Page 8-16.
	3.	Remove the Left Rear Cover - Refer
		to Page 8-15.
	4.	Remove the Back Cover - Refer to
		Page 8-23.
	5.	Remove the Electronics Module -
		Refer to Page 8-92.
	6.	Remove the Lower Right EMC Cover
		- Refer to Page 8-32.
	7.	Remove the Booster Fan for better
		access - Refer to Page 8-103.
	8.	Reach under the Center Guide and
		carefully remove the Media Sensor
		mount by pulling it down gently (as
		shown below).

TIP Pull down the Media Sensor by inserting a finger on each side of the sensor and pulling down.

1. Insert fingers

2. Pull down

8-104 HP DesignJet 5000 Series Printers Service Manual